993 Brakes on Type3

This kit adapts 993 brakes to a T1 (BJ, SB) or T3 spindle (shown). This kit adapts 993 brake components to stock height disk spindles. (Dropped spindles can also be used). The hubs are modified to take T1 bearings. Grease seal adaptors allow the use of stock beetle grease seals.

The spindles require machining to mount the caliper. The spindle will no longer be able to take a stock T1 caliper.

The kit included machining of YOUR of your hubs to take beetle bearings, fabrication of two caliper brackets, maching of YOUR spindles to accept the caliper bracket, installed German bearings/seals and all required fasteners.+7mm offset increase per side.

$c340

vDub Engineering © Copyrigh 2011 All Rights Reserved